![]() SYSTEM_THREAD(ENABLED) // To not block the main program while searching for WiFiĬarloop carloop // Instantiate Carloop ObjectĬarloop.begin() // Creates the appropriate CANChannel Particle Photon (ECU Simulator) => Carloop CAN Hitch => Female extension OBD cable => Carloop adapter => Particle electronĪgain, this setup works with the ELM327 the photon receives all the requests sent by the phone app through the ELM327, but also again, the photon (the ECU simulator) doesn't receives messages when switched to the electron. I'm trying other approach I'm using the can hitch connected as follows: Is there any consideration I have to do in the arduino side to be compatible with the carloop adapter/library ? If I test the code using the elm327 (bluetooth) and an app in my phone, the messages are sent/received as expected When I connect the Carloop adapter and a sample code reader sketch the communication isn't done.Īlso, I've tested the carloop adapter and the same sketch in my car and the communication is performed well. ![]() OBDIImsg = 23 // P0217 Sobrecalentamiento del motor LOW OBDIImsg = 2 // P0217 Sobrecalentamiento del motor HIGH ![]() I'm building my own car simulator using the next components:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |